GE GSD6300J10WW Installation Instructions Manual

Built-in dishwasher
Hide thumbs Also See for GSD6300J10WW:

Advertisement

Quick Links

Installation
Instructions
Built-In
Dishwasher
l If you have questions, call 800-GECARESor visit our website at: www.GEAppliances.com
I
BEFORE YOU BEGIN
Read
these
instructions
completely
and
carefully.
•IMPORTANT
- C.,se,,'e . Ug,,,'e,',,i,,g
codes
and
ordinances.
Note
to Installer
- Be sure
to leave
these
instruc-
ti(ms
for
the
consumer's
and
local
inspector's
use.
• Note
to Consumer
- Keep
these instructions
with
your
(-)wiper's
Manual fi)r
fllture
retbrei_ce.
Skill Level
- Installation
of this
dishwasher
requires
basic
mechanical
and
electrical
skills.
Proper
installa-
tion
is the
responsibility
of the
installer.
Product
failure
due
to improper
installation
is not
covered
under
the
GE Appliance
Waxranty.
• Completion
Time
- 1
to
3 Hours, New installations
require
m ore
tim e than
replacement
installation
s.
•IMPORTANT
- The dish,,'.she, MUST _,e
installed
to alhm
tot
fllture
remoxal
fl'om
the
enclo-
sure
if serxice
is required.
If vou
receixed
a damaged
dislmasher,
you
should
immediateh'
contact
your
dealer
or builder.
Optional
Accessories
- See the o,vne,"s m.n_,.1
fin" axailable
custom
panel
kits.
FOR YOUR SAFETY
Read
and observe
all CAUTIONS
and WARNINGS
shown
throughout
these
instructions.
While performing
installations
described
in this booklet,
gloves,
safety
glasses
or goggles
should
be worn.
READ CAREFULLY.
KEEP THESE INSTRUCTIONS.

Advertisement

Table of Contents
loading

Summary of Contents for GE GSD6300J10WW

  • Page 1 CAUTIONS and WARNINGS to improper installation is not covered under shown throughout these instructions. While performing GE Appliance Waxranty. installations described in this booklet, gloves, safety • Completion Time 3 Hours, New installations glasses or goggles should be worn.
  • Page 2: Parts Supplied

    Installation Preparation Trim Pieces PARTS SUPPLIED: [] Two#8 Phillips flat head wood screws, 5/8" long to secure dishwasher to underside of countertop orto side of cabinetry. (Tapedto top or side of dishwasher.) [] Side and top trim pieces 2 Wood Screws 4,#8 Pan head Phillips Screws Side Mounting Brackets [] 2 Side mounting brackets with 4 mounting screws 3/8"long for side mounting...
  • Page 3 Installation Preparation PREPARE DISHWASHER ENCLOSURE • The dishwasher must be installed so that drain hose is no m ore than 10 tibet in length for proper drainage. • The dishwasher must be fifllv enclosed on the top, sides and back, mad must not support may part...
  • Page 4: Prepare Electrical Wiring

    Installation Preparation PREPARE ELECTRICAL WIRING FOR PERSONAL SAFETY: Remove Alternate -_"", house fllse or open circuit breaker Receptacle t before begilming installation. Do not use an extension cord or adapter phlg with this appliance. Electrical Requirements • This appliance must be supplied with 120V, 60 Hz., and Cabinet...
  • Page 5: Prepare Hot Water Line

    Installation Instructions PREPARE HOT WATER LINE [STEP 1] CHECK DOOR BALANCE • The line enter fl'om either side, rear or floor With dishwasher on wood skid, check the door balance within shaded area shown in Figure by opening closing the door. •...
  • Page 6: [Step 3] Remove Toekick

    Installation Instructions [STEP 3] REMOVE TOEKICK [STEP 5] INSTALL 90 ° ELBOW • Remoxe the mo toekick screws, • Wrap 90 ° elbow with thread seal tape. • Install a 90 ° elbow onto the water xalxe. Frontof Dishwasher Remove 2 Toekick S crews FigureI 90°...
  • Page 7: Step 8] Slide Dishwasher Partially Into Cabinet

    Installation Instructions ISTEP91 INSTALL TRIM PIECES ISTEP 71 INSERT DRAIN HOSE THROUGH CABINET Skip this step if trim is not supplied with the dishwasher, • Locate trim strips inside dishwasher. • Upright dishwasher position in fl'ont of the • Press trim onto the tub flange on each side.
  • Page 8 Installation Instructions • Lexel tile dish- ISTEP 111 LEVEL DISHWASHER x_asher bya(!justing AccessHob IMPORTANT - Dishwasher must be level fl)r proper the It)ill" leveling dish rack operation and wash pertormance. legs individually. • If a(!justment to tile • Place level on right rear leveling door and rack...
  • Page 9: Drain Line Installation

    Installation Instructions [STEP 13 1CONNECT WATER SUPPLY Com_ect water supply line to 90 ° elbow. • Slide compression inK, then terrule over water line. • Insert water line into 90 ° elbow. • Slide ferrule against elbow secure with compres- sion IMPORTANT: Check...
  • Page 10: Connect Power Supply

    Installation Instructions ISTEP151 [STEP 16] PRE-TEST CHECK LIST CONNECT POWER SUPPLY Review this list after installing your dishwasher avoid charges for a service call that is not covered Skip this step if equipped with power cord your warranty, Verify that power is turned off at the source, [] Check...
  • Page 11: [Step 18] Replace Toekick

    Installation Instructions ISTEP 171 DISHWASHER WET TEST [STEP 18] REPLACE TOEKICK [] Turn on power supply plug power cord into • Place toeki('k against legs ol the dish_asher. outlet, if equipped). [] Latch door. [] Push "Norn_al Wash" button. [] Push start/reset once.
  • Page 12 _No. 3 1-30530 • No.20601559P070| SPECIFICATIONS SUBJECT T OCHANGE WITHOUT NOTICE (N.D.212) 6/01...

Table of Contents