Table of Contents
Advertisement
Configuring and Mounting the Drive
www.seagate.com
Figure 1 Attaching SATA cabling
Signal connector
Power connector
Signal cable
Power cable
Each cable is keyed to ensure correct orientation. NAS HDD drives support latching SATA connectors.
3.4 Drive mounting
You can mount the drive in any orientation using four screws in the side-mounting holes or four screws in the
bottom-mounting holes. Refer to
for drive mounting dimensions. Follow these important mounting
Figure 2
precautions when mounting the drive:
• Allow a minimum clearance of 0.030 inches (0.76mm) around the entire perimeter of the drive for cooling.
• Use only 6-32 UNC mounting screws.
• The screws should be inserted no more than 0.150 inch (3.81mm) into the bottom or side mounting holes.
• Do not overtighten the mounting screws (maximum torque: 6 inch-lb).
Figure 2 Mounting dimensions (2TB,3TB and 4TB)
Temperature
Check Point
24
NAS HDD Product Manual, Rev. A
Advertisement
Table of Contents
