Table of Contents
Advertisement
Drive Specifications
Table 5 Radio frequency environments
Electrostatic discharge
Radiated RF immunity
Electrical fast transient
Surge immunity
Conducted RF immunity
Voltage dips, interrupts
2.12 Reliability - Mean Time Between Failure
The product will achieve a Mean Time Between Failure Rate (MTBF) of 1,000,000 hours when operated in an
environment of ambient air temperatures of 25°C. Operation at temperatures outside the specifications shown in
may increase the product MTBF. MTBF is a population statistic that is not relevant to individual units.
Section 2.9
• MTBF specifications are based on the following assumptions for NAS environments:
• 8760 power-on hours per year
• 10,000 average motor start/stop cycles per year
• Operations at nominal voltages
• Temperatures outside the specifications in
Operation at excessive I/O duty cycle may degrade product reliability. The NAS environment of power-on hours,
temperature, and I/O duty cycle affect the product MTBF. The MTBF will be degraded if used in an enterprise
application.
2.13 Warranty
To determine the warranty for a specific drive, use a web browser to access the following web page:
support.seagate.com/customer/warranty_validation.jsp
From this page, click on the "Verify Your Warranty" link. You will be asked to provide the drive serial number,
model number (or part number) and country of purchase. The system will display the warranty information for your
drive.
2.14 Agency certification
2.14.1 Safety certification
These products are certified to meet the requirements of UL60950-1, CSA60950-1 and EN60950 and so marked
as to the certify agency.
2.14.2 Electromagnetic compatibility
Hard drives that display the CE mark comply with the European Union (EU) requirements specified in the
Electromagnetic Compatibility Directive (2004/108/EC) as put into place 20 July 2007. Testing is performed to the
levels specified by the product standards for Information Technology Equipment (ITE). Emission levels are defined
by EN 55022, Class B and the immunity levels are defined by EN 55024.
Drives are tested in representative end-user systems. Although CE-marked Seagate drives comply with the
directives when used in the test systems, we cannot guarantee that all systems will comply with the directives.
The drive is designed for operation inside a properly designed enclosure, with properly shielded I/O cable (if
necessary) and terminators on all unused I/O ports. Computer manufacturers and system integrators should
confirm EMC compliance and provide CE marking for their products.
20
Contact, HCP, VCP: ± 4 kV; Air: ± 8 kV
80MHz to 1,000MHz, 3 V/m,
80% AM with 1kHz sine
900MHz, 3 V/m, 50% pulse modulation @
200Hz
± 1 kV on AC mains, ± 0.5 kV on external I/O
± 1 kV differential, ± 2 kV common,
AC mains
150kHz to 80MHz, 3 Vrms, 80% AM with 1kHz
sine
0% open, 5 seconds
0% short, 5 seconds
40%, 0.10 seconds
70%, 0.01 seconds
Section 2.9
B
A
B
B
A
C
C
C
B
may reduce the product reliability.
NAS HDD Product Manual, Rev. A
www.seagate.com
EN61000-4-2: 95
EN61000-4-3: 96
ENV50204: 95
EN61000-4-4: 95
EN61000-4-5: 95
EN61000-4-6: 97
EN61000-4-11: 94
Advertisement
Table of Contents
