Installation; Wiring Precautions - Audiopipe 1200W Owner's Manual

We recommend you have the installation done by Authorized Audiopip dealer. The ground
wire should be connected directly with the chasis of your vehicle which should be a metal
to metal ground point connection. The amplifier must be mounted securely at a solid, dry
and low vibration surface in the trunk or passenger area. Mount the amplifier in an open
air area to insure proper heat dissipation. Mount the amplifier in a place where you can
access it easily to set the input controllers. Install all amplifier cables as far as possible
from car electrical cables such as the car ignition cable.
1. When bridging two amplifiers please refer to the bridging wiring chart.
2. When bridging two amplifiers you should use same model amplifiers.
3. Please make sure the negative speaker terminal of two amplifiers are connected by
the same gauge cables as the positive terminal being used.
4. DO NOT connect any signal cables with the input RCA jacks when bridged as slave
unit.
5. The LPF, Input level and remote functions will be disabled on slave amplifier when
bridged.
6. All the functions of the slave amplifier will be adjusted by the master amplifier.
- 4 -
English