Hardware Hookup - Crestron CHV-RTS Installation Manual

Crestron CHV-RTS & CHV-RTHS Temperature & Humidity Sensors
5. Connect the wires from the thermostat to the 10 inch (254 mm)
Wiring the CHV-RTS and CHV-RTHS
6. Press fit the sensor into the hole; the clips on either side of the
NOTE: The face of the sensor may be painted or wallpapered to match
the wall. However, keep the small gap around the outer edge clear of any
obstructions.

Hardware Hookup

CHV-RTS and CHV-RTHS sensors connect to the terminal blocks on the
back plate of the CHV-TSTAT, CHV-THSTAT, CHV-TSTATEX, and
CHV-TSTATEX-FCU thermostats (all sold separately).
Installation Guide – DOC. 8189D
NOTE: In situations where ordinary two-conductor thermostat
wire (18 to 20 gauge) has been installed, it may be used for runs up
to 100 feet (30 meters). This is not a preferred method of
installation.
NOTE: If multi-conductor cables are used, the unused conductors
must NOT be used for other purposes and must be left
unconnected at both ends.
sensor pigtail (22 AWG x 12" black/black twisted pair) using wire
nuts. The wires are non-polarized. (Refer to "Hardware Hookup,"
below.)
sensor hold it in place.
Temperature/Humidity Sensors: CHV-RTS/CHV-RTHS • 5