Table of Contents
Advertisement
Crestron CHV-RTS & CHV-RTHS Temperature & Humidity Sensors
Remote Temperature & Humidity
Sensors: CHV-RTS & CHV-RTHS
Introduction
The CHV-RTS and CHV-RTHS are wall-mounted remote temperature
and relative humidity sensors* designed for use with select Crestron
thermostats. Using CAT5 or similar low-capacitance wire, the remote
sensor may be mounted up to 500 feet (152 meters) from the thermostat.
One-piece mounting and a single non-polarized twisted-pair connection
make the CHV-RTS and CHV-RTHS simple to install. The 1 1/2 inch
(39 mm) diameter face of each protrudes just 1/8 inch (3 mm) from the
wall surface and is easily painted or wallpapered to blend into the wall
surface.
Up to four CHV-RTS sensors may be connected to a single
CHV-THSTAT, CHV-TSTAT, CHV-TSTATEX, or
CHV-TSTATEX-FCU thermostat (all sold separately). Up to two
CHV-RTHS sensors may be connected to a single CHV-THSTAT or
CHV-TSTAT thermostat (all sold separately).
NOTE: When connecting a CHV-RTS or CHV-RTHS sensor to a
CHV-THSTAT or a CHV-TSTAT (models without infiNET EX
that thermostat firmware version 1.xx supports two optional remote
sensors, while thermostat firmware version 2.xx and later supports four
optional remote sensor inputs, in any combination, for each thermostat.
NOTE: If the maximum number of sensors is exceeded, some of the
sensors will be ignored by the system.
* Humidity sensor available only on CHV-RTHS.
Installation Guide – DOC. 8189D
Temperature/Humidity Sensors: CHV-RTS/CHV-RTHS • 1
®
®
), note
Advertisement
Table of Contents
