Troubleshooting - Bissell 8852 SERIES User Manual

Troubleshooting

Problem Possible causes
Bladder may be empty.
2-in-1 tank may not be seated
Reduced
properly.
spray OR
Pump may have lost prime.
no spray
The motor belt may be broken.
DirtLifter
The brush belt or motor belt is
PowerBrush off or broken.
does not turn
ReadyTools dial may be on the
wrong setting for the cleaning job.
Poor tool position. (Hand held
attachments only).
Removable nozzle may not be
properly attached.
Cleaner
not picking
up solution
2-in-1 tank lid is not properly installed. Re-install lid; refer to images on page 7.
2-in-1 tank is not properly seated.
2-in-1 tank has picked up maxi-
mum dirty water.
The lint screen may be clogged.
Please do
not return
this product
to the store.
Other maintenance or service not included in the manual should
be performed by an authorized service representative.
Thank you for selecting a BISSELL product.
For any questions or concerns, BISSELL is happy to
be of service. Contact us directly at 1-800-237-7691.
WARNING
To reduce the risk of electric shock, turn power switch
off and disconnect plug from electrical outlet before
performing maintenance or troubleshooting checks.
Remedies
Turn power switch off; Refill bladder
with clean hot tap water and formula.
Turn power switch off; remove tank
and reseat tank.
Turn power switch off; after 1 minute turn
on and depress spray release trigger.
Follow belt replacement instructions
on page 12.
Follow belt replacement instructions
on page 12.
Set ReadyTools dial to either floor
cleaning or tools.
Adjust angle; apply more downward
pressure.
Make sure nozzle is on correctly by
slightly raising front of machine to line
up slots on the base of the machine
with the hooks on nozzle. Attach at
base first and then click nozzle into
place. Refer to image 5 on page 8.
2-in-1 tank must be firmly seated to
function; remove and reseat 2-in-1 tank.
Empty 2-in-1 tank and refill, refer to
the Operation section.
Clean out lint screen. Refer to page 8.
www.BISSELL.com 800.237.7691
13