Turbo Air TMW-1100E Service Manual page 51

(1) Remove the gasket door from door weld as.
(2) Remove the barrier screen inner from weld as.
(3) Remove the door frame from door weld as.
(4) Remove the stopper hinge top from door weld as.
(5) Remove the spring and the hook.
(6) Remove the barrier screen outer from door frame.
(7) Reverse the above steps for reassembly.
4. Method to reduce the gap between the door seal and the oven front surface.
(1) To reduce gap located on part 'A'
• Loosen two screws on stopper hinge top, and
then push the door to contact the door seal to
oven front surface.
• Tighten two screws.
(2) To reduce gap located on part 'B'
• Loosen two screws on stopper hinge under, and
then push the door to contact the door seal to
oven front surface.
• Tighten two screws.
NOTE : A small gap may be acceptable if the microwave leakage does not exceed 4mW/cm
49
2 .