Turbo Air TMW-1100E Service Manual page 20

8. To remove wind guide assembly.
1) Remove two screws which secures the wind guide assembly and cover hole *0 and noise filter.
2) Draw forward the wind guide assembly.
3) Pull the noise filter from the wind guide assembly.
4) Pull the fan from the motor shaft.
5) Remove two screws which secure the motor shaded pole.
6) Remove the motor shaded pole.
7) Reverse the above steps for reasembly.
9. To remove H.V.transformer.
1) Remove four screws holding the H.V.transformer.
2) Remove the H.V.transformer.
3) Reverse the above steps for reassembly.
Noise Filter:Only KOR-1P5CBB
18
KOR-1P55BB