Turbo Air TMW-1100E Service Manual page 19

6. To remove high voltage capacitor.
1) Remove a screw which secures the grounding ring
terminal of the H.V. diode and the capacitor holder.
2) Remove the H.V. diode from the capacitor holder.
3) Reverse the above steps for reassembly.
High voltage circuit wiring
7. To remove magnetron.
1) Remove a screw which secures the magnetron.
2) Remove the magnetron.
3) Reverse the above steps for reassembly.
NOTE : Never install the magnetron without the metallic gasket plate which is packed with each magnetron to
prevent microwave leakage. Whenever repair work is carried out on magnetron, check the microwave
leakage. It shall not exceed 4mW/cm
Metalic
gasket
plate
Cooling fin
<MAGNETRON>
2 for a fully assembled oven with door normally closed.
Magnetron antenna
Stub
Filament
terminal
17