Autoprogram - Philips 32PFL5708/F7 User Manual

Autoprogram

If you switch wires (e.g. between antenna and CATV) or if you move
the unit to a different area after the initial setting, or if you restore the
DTV channels you deleted, it is recommended to use AutoProgram to
perform a new channel search.
1
(MENU) to display Home Menu and use ▲▼ to select
Press
Setup, then press OK.
2
Use ▲▼ to select Autoprogram, then press OK.
3
Use ▲▼ to select Cable or Antenna, then press OK.
4
Press OK to select Start now.
• Autoprogram will start automatically.
Picture
Autoprogram
Please wait while the system is scanning for channels.
Sound
Auto programming may take more than 20 minutes to
complete.
Setup
59%
Features
USB
Digital Channels
Analog Channels
5
Follow the on-screen instructions to complete the installation.
Note
• After setting Autoprogram, using CH + / CH − skips unavailable programs
automatically.
• If you are not receiving a signal from your cable service, contact the cable provider.
• If you press or during Autoprogram, the setup of TV channels will be canceled.
• Even if Autoprogram is completed, the channel setting will be lost if the AC power cord
is unplugged before the unit goes into Standby mode by pressing .
• The PIN code will be required once you set a PIN code in the Child lock.
• If you want to change your PIN code, follow the instruction of Change PIN.
7 CH
0 CH
BACK
Exit
p. 23
p. 25
Channel list
You can make a list of your preferred TV channels so that you can find
those channels more easily.
1
(MENU) to display Home Menu and use ▲▼ to select
Press
Setup, then press OK.
2
Use ▲▼ to select Channel list, then press OK.
Picture Highlight channels for Ch Up/Down key
selection.
Sound
Setup
Features
USB
Navigate
3
Use ▲▼ to select the desired channel, then press OK repeatedly
to switch between skip/watch.
• The greyed out channels indicates exclusion, which means those
channels will be skipped when using CH + / CH − key (on your
TV remote control) for channel browsing.
• The white channels indicates inclusion, which means those
channels will be shown when using CH + / CH − key (on your
TV remote control) for channel browsing.
DTV 1.2
ATV 10.0
DTV 10.1
DTV 10.2
ATV 66.0
BACK
Watch / Skip Back
OK
21
English