Philips 32PFL5708/F7 User Manual page 14

Settings assistant
You have set up your viewing preferences.
BACK
Store
OK
5
Use ▲▼ to select Antenna for TV channels or Cable for CATV
channels, then press OK.
Setup Wizard (3/6)
Please select TV RF tuning band
Previous
Select
OK
– When Antenna is selected, the TV detects antenna signals. It searches
for DTV and Analog TV channels available in your area.
– When Cable is selected, the TV detects signals supplied by cable. It
searches for DTV, Analog TV and Cable channels available in your
area.
• Autoprogram will begin.
Setup Wizard (4/6)
Please check that the RF cable is connected properly.
Scan time may take over 20 minutes.
START START
Previous
Select
OK
Setup Wizard (5/6)
Searching. Please wait
Searching CH
Digital Channels Found
Analog Channels Found
50%
MENU
MENU
Exit
Back
Antenna
Cable Cable
Cancel
OK
Cancel
OK
Channel 33
5
1
Exit
Setup Wizard (6/6)
Congratulations. TV Setup is done.
MENU
Note
• If you are not receiving a signal from your cable service, contact the Cable provider.
• If you press during AutoProgram, this setup of TV channels will be canceled.
• The initial AutoProgram function can be executed for either Antenna or Cable only
once. When you change the connection (Antenna / Cable), set Autoprogram again.
p. 21
After an initial setup is completed...
• If you want to scan the channels automatically again.
Autoprogram
• If you want to change to another language.
Language
• If you want to change the location setting.
Location
• If you want to restore the picture setting.
Settings assistant
14
Exit
p. 21
p. 22
p. 26
p. 18
English