Connecting With Wired Lan; Computer Operation; Connecting With Wireless Lan - Panasonic TH-65PB1U Network Operation Manual

Connecting with Wired LAN

To use the network function, make the necessary settings in [NETWORK SETUP] and be sure to set [CONTROL
I/F SELECT] to [LAN]. (See page 9)
When [LAN] is set, the slot power is turned on, and power indicator is lit orange under the condition of power off
with remote control (stand-by state), regardless of the [Slot power] setting.

Computer operation

Connection can be made with wired LAN. However, con¿ rm to your system administrator on network settings
before changing any settings.
1
Turn on the computer.
2
Make the network setting according to your system administrator.
If the Display settings are the default settings (See page 10), the computer can be used with the following
network settings.
IP ADDRESS
SUBNET MASK
GATEWAY

Connecting with Wireless LAN

You can con¿ gure settings when the wireless module (ET-WM200U) is mounted.
Computer operation
1
Make the network setting according to your system administrator.
If the Display settings are the default settings (See page 13), then the computer can be used with the
following network settings.
IP ADDRESS
SUBNET MASK
GATEWAY
2
Click [Start] [Connect To
network of [SSID] set with the Display, and then click [Connect
If the Display setting is the factory setting, then [SSID] is [Panasonic Display].
¼
The names are for Windows XP. In Windows Vista/Windows 7, the procedure will be [Start] [Connect To].
•
If you use any wireless utility other than Windows [Wireless Network Connection], follow its operation
procedure for connection.
•
If you use the access point, con¿ gure the Display and each network setting of the computer following the
instruction of the network administrator.
18
192.168.10.101
255.255.255.0
192.168.10.1
192.168.11.101
255.255.255.0
192.168.11.1
¼
] [Wireless Network Connection
¼
], select the wireless
¼
].