Factory Settings - NETGEAR N600 JNDR3000 User Manual

Factory Settings

You can return the router to its factory settings. Use the end of a paper clip or a similar object
to press and hold the Restore Factory Settings button on the back of the router for at least
five seconds. The router resets and returns to the factory settings. Your device returns to the
factory configuration settings shown in the following table.
Table 4. Factory default settings
Feature
Router login User login URL
User name (case-sensitive)
Login password (case-sensitive)
Internet WAN MAC address
connection
WAN MTU size
Port speed
Local network LAN IP
(LAN)
Subnet mask
DHCP server
DHCP range
Allow a registrar to configure this
router
DHCP starting IP address
DHCP ending IP address
DMZ
Time zone
Time zone adjusted for daylight
savings time
SNMP
Firewall Inbound (communications coming
in from the Internet)
Outbound (communications going
out to the Internet)
Source MAC filtering
N600 Wireless Dual Band Router JNDR3000
Default behavior
www.routerlogin.com or www.routerlogin.net
admin
password
Use default hardware address
1500
10/100 Mbps Autosensing
192.168.1.1
255.255.255.0
Enabled
192.168.1.2 to 192.168.1.254
Enabled
192.168.1.2
192.168.1.254
Disabled
GMT for WW except NA and GR, GMT+1 for GR, GMT-8
for NA
Disabled
Disabled
Disabled (except traffic on port 80, the HTTP port)
Enabled (all)
Disabled
Supplemental Information
128