Table of Contents
Advertisement
To set up port triggering, you need to know which inbound ports the application needs. Also,
you need to know the number of the outbound port that triggers the opening of the inbound
ports. You can usually determine this information by contacting the publisher of the
application or user groups or newsgroups.
To enable port triggering:
1.
Select ADVANCED > Advanced Setup > Port Forwarding/Port Triggering.
2.
Select the Port Triggering radio button.
The following screen displays:.
3.
Clear the Disable Port Triggering check box if it is selected.
Note:
If the Disable Port Triggering check box is selected after you configure
port triggering, port triggering is disabled. However, any port triggering
configuration information you added to the router is retained even though it is
not used.
4.
In the Port Triggering Timeout field, enter a value up to 9999 minutes.
This value controls the inactivity timer for the designated inbound ports. The inbound
ports close when the inactivity time expires. This is required because the router cannot be
sure when the application has terminated.
To add a port triggering service:
1.
Select ADVANCED > Advanced Setup > Port Forwarding/Port Triggering.
1.
Select the Port Triggering radio button.
2.
Click the Add Service button.
N600 Wireless Dual Band Router JNDR3000
Advanced Settings
107
Advertisement
Table of Contents
