HP ProLiant DL385p Specification page 58

QuickSpecs
Technical Specifications
HP Smart Array P420i
Controller
Emissions Classification
(EMC)
Dimensions
Disk Drive and Enclosure
Interface - Transfer Rate
SAS Connectors
Cache Memory Speed
Server Interface
SAS Speed
Cache Memory
Logical Drives Supported Up to 64 logical drives with cache
Host Memory Addressing 64-bit, supporting greater than 4GB server memory space
RAID Support
DA - 14329 Worldwide — Version 25 — December 13, 2013
HP ProLiant DL385p Generation 8 (Gen8)
LWAd
LpAm
FCC Rating
Normative Standards
NOTE: Product conformance to cited product specifications is based on
sample (type) testing, evaluation, or assessment. This product or family of
products is eligible to bear the appropriate compliance logos and statements.
NOTE: The Listed sound levels apply to standard shipping configurations.
Additional options may result in increased sound levels.
Embedded
6Gb/s SAS (Serial Attached SCSI)
3Gb/s SATA (Serial ATA)
2 internal 4X connectors
DDR2-800MHz with 40 or 72-bit wide bus
x4 PCIe 2.0 provides 2GB/s maximum bandwidth
(8) 6Gb/s SAS links provide 4.8GB/s maximum bandwidth
Zero Memory RAID has no cache memory
40-bit 256MB ECC protected cache (battery upgrade available)
72-bit 512MB BBWC or 72-bit 512MB and 1G FBWC
Zero Memory, Up to 2 logical volumes (8 physical drives)
RAID 6, 60 (Advanced Data Guarding)
RAID 5, 50 (Distributed Data Guarding)
NOTE: A minimum of 512 MB cache is required to enable RAID 5, 50, 6, 60
NOTE: HP Smart Array Advanced Pack (SAAP 2.0) is no longer required to
enable RAID 6 & 60 (Advanced Data Guarding). However, controller must be in
firmware version 4.68 (or later).
RAID 1+0 (Striping & Mirroring)
RAID 0 (Striping), RAID 1 (Mirroring)
5.5 B
37 dBA
Class A
CISPR 22; EN55022; EN55024; FCC CFR 47, Pt 15;
ICES-003; CNS13438; GB9254; K22;K24; EN
61000-3-2; EN 61000-3-3; EN 60950-1; IEC
60950-1
Page 58