HP 5120 EI Series Specification page 13

QuickSpecs
Configuration
PDU Cable NA/MEX/TW/JP
C15 PDU Jumper Cord (NA/MEX/TW/JP)
PDU Cable ROW
C15 PDU Jumper Cord (ROW)
HP 5120-48G-PoE+ EI Switch w/2 Intf Slts - CTO
48 RJ-45 autosensing 10/100/1000 ports
4 dual-personality ports; PoE auto-sensing 10/100/1000Base-T or SFP
min=0 \ max=4 SFP Transceivers
2 - port expansion module slots
1 - Power Supply Included
1U - Height
PDU Cable NA/MEX/TW/JP
C15 PDU Jumper Cord (NA/MEX/TW/JP)
PDU Cable ROW
C15 PDU Jumper Cord (ROW)
Configuration Rules:
Note 1 The following Transceivers install into this Switch: (Use #0D1 if switch is CTO)
HP X120 1G SFP LC SX Transceiver
HP X120 1G SFP LC LX Transceiver
HP X120 1G SFP RJ45 T Transceiver
HP X120 1G SFP LC BX 10-U Transceiver
HP X120 1G SFP LC BX 10-D Transceiver
HP X124 1G SFP LC LH40 1310nm Transceiver
HP X120 1G SFP LC LH40 1550nm Transceiver
HP X125 1G SFP LC LH70 Transceiver
Note 3 Localization (Wall Power Cord) required on orders without #B2B, #B2C (PDU Power Cord) or #B2E.
(See Localization Menu)
Note 5 If this Switch is selected, Then a Minimum of 1 factory integrated accessory must be ordered and integrated to CTO
chassis. See Menu below, option must have a #0D1 to be integrated to the CTO Chassis.
Note 7 If the Switch Chassis is to be Box Level Factory Integrated (CTO), Then the #0D1 is required on the Switch Chassis
and integrated to the JG706A - HP 51xx CTO Enablement. (Min 1/Max 1 Switch per SSP)
DA - 13850 North America — Version 24 — December 17, 2013
HP 5120 EI Switch Series
JE069A#B2B
JE069A#B2C
JG237A
See Configuration
Note:1, 3, 5,7
JG237A#B2B
JG237A#B2C
JD118B
JD119B
JD089B
JD098B
JD099B
JD061A
JD062A
JD063B
Page 13