HP 571956-B21 Specification page 8

QuickSpecs
Supported Products
[Bay 1]
[Bay 3]
[Bay 5]
[Bay 7]
[Bay 1]
[Bay 3]
[Bay 5]
[Bay 7]
1
Requires HP ProLiant BL G7 server blades with HP NC551i or HP NC553i Dual Port FlexFabric 10Gb Converged Network Adapter.
2
Supports Ethernet only when connected to server blades without embedded NC551i Dual Port FlexFabric 10Gb Converged Network
Adapter.
3
Requires full-height servers.
Required Cabling
NOTE: Twinax direct attach copper (0.5 to 7m). 7m is not supported on ports X1-X4
NOTE: Direct Attach Copper cables listed in the options section below is fully supported by HP. HP recommends use of these cables. If
not identified as a "supported" DAC, VC will allow the connection to proceed if the discovery process indicates the cable meets the
following criteria: connector=copper pigtail; transceiver code=active cable or passive cable; speed >=10Gb; length between 1m and
7m, inclusive. The connection is logged as an unsupported cable. Prior to requesting support from HP, a DAC from the supported list
must be used to validate the issue.
Maximum Distances
SR
LR
LRM
VC Flex-10
VC FlexFabric
VC Flex-10
VC Flex-10/10D
VC FC
VC FlexFabric
Empty
VC Flex-10
2
VC FlexFabric
VC FlexFabric
VC Flex-10
VC Flex-10/10D
VC FC
VC FlexFabric
VC Flex-10
VC Flex-10/10D
3
VC FC
VC FlexFabric
Multimode OM1
62.5/125 micron
2 - 26m/33m*
0.5 - 220m
DA - 13652 Worldwide — Version 20 — November 5, 2013
HP Virtual Connect FlexFabric 10Gb/24-Port Module
-> VC Flex-10 or Empty
-> VC FlexFabric or Empty
-> VC Flex-10 or Empty
-> VC Flex-10/10D or Empty
-> VC FC or Empty
-> VC FlexFabric or Empty
-> Empty
-> VC Flex-10 or Empty
2
-> VC FlexFabric or Empty
-> VC FlexFabric or Empty
-> VC Flex-10 or Empty
-> VC Flex-10/10D or Empty
-> VC FC or Empty
-> VC FlexFabric or Empty
-> VC Flex-10 or Empty
-> VC Flex-10/10D or Empty
3
-> VC FC or Empty
-> VC FlexFabric or Empty
Multimode OM2
50/125 micron
2 - 82m
0.5 - 220m
[Bay 2] Flex-10/Enet LOM
[Bay 4] FlexFabric Adapter Mezzanine
[Bay 6] Flex-10/Enet, FC HBA or FlexFabric
Adapter Mezzanine
[Bay 8]
[Bay 2] Flex-10/Enet LOM
[Bay 4] FlexFabric Adapter Mezzanine
[Bay 6] Flex-10/Enet, FC HBA or FlexFabric
Adapter Mezzanine
[Bay 8] Flex-10/Enet, FC HBA or FlexFabric
Adapter Mezzanine
Multimode OM3
50/125 micron
2 - 300m
0.5 - 220m
Singlemode
9 micron
2 -10km
Page 8