NETGEAR N300 User Manual page 79

The router is always in dual-band concurrent mode, unless you turn off one radio. If you
enable the wireless repeater in either radio band, the wireless base station or wireless
repeater cannot be enabled in the other radio band. However, if you enable the wireless
base station in either radio band and use the other radio band as a wireless router or
wireless base station, dual-band concurrent mode is not affected.
For you to set up a wireless network with WDS, both access points must meet the
following conditions:
• Both access points must use the same SSID, wireless channel, and encryption mode.
• Both access points must be on the same LAN IP subnet. That is, all the access point
LAN IP addresses are in the same network.
• All LAN devices (wired and wireless computers) must be configured to operate in the
same LAN network address range as the access points.
To view or change the wireless repeater settings for the router:

1. Select ADVANCED > Advanced Setup > Wireless Repeating Function.
2. Configure the following wireless repeater settings:
• Enable Wireless Repeating Function. Select the check box for the 2.4 GHz or 5
GHz network to use the wireless repeating function.
• Wireless MAC of this router. This field displays the MAC address for your router for
your reference. You need to enter this MAC address in the corresponding Wireless
Repeating Function screen of the other access point you are using.
• Wireless Repeater. If your router is the repeater, select this check box.
• Repeater IP Address. If your router is the repeater, enter the IP address of the other
access point.
• Disable Wireless Client Association. If your router is the repeater, selecting this
check box means that wireless clients cannot associate with it. Only LAN client
associations are allowed.
N300 Wireless Router JWNR2000v3
Advanced Settings
79