NETGEAR N300 User Manual page 12

4. Locate the cable (A) that is still attached to your computer.
Insert that cable into a yellow LAN port on the router, as shown in the following figure:
5. Connect any additional wired computers to your router by inserting an Ethernet cable from a
computer into one of the three remaining LAN ports.
6. Start your network in the correct sequence.
See the following procedure.
CAUTION:
Failure to start or restart your network in the correct sequence could
prevent you from accessing the Internet.
To start your network:

1. Plug in and turn on the cable or DSL modem. Wait two minutes.
2. Plug the power adapter into the AC power adapter input on the router.
N300 Wireless Router JWNR2000v3
A
Hardware Setup
12