Exit; Page; Handset To Handset Paging - GE 21029 User Manual

• Press the cid/vol () button to review the newest call and scroll to older
calls (lower numbers).
2. Press theTALK/END/call back or SPKR buttons.The number dials
automatically.
If you get a busy signal and want to keep dialing the number, press the
REDIAL button to quickly redial the number.

Exit

Press the *exit button to exit a menu function and return to the standby
screen.

Page

The page feature helps you locate a misplaced handset.To send and receive
pages, all handsets must be registered. If your handset is not registered,
follow the instructions in the Registration section of this manual.

Handset to Handset Paging

Handsets are named HANDSET 1, HANDSET 2, and HANDSET 3
respectively.
1. Make sure the phone is OFF (not in talk mode).
2. Press and release the page/int button on a handset. PAGING
EXTENSION? shows in the display.
3. Use the touch-tone pad to enter the handset number you want to page.
NOTE: If more than 2 handsets have been registered, you can page all
handsets by pressing 5.
4. To cancel the page, press the *exit button, or press the page/int button.
Or you may pressTALK/END/call back on the receiving handset to enter
intercom mode.
Paging from the Base/Group Page
Use the base-only to page all registered handsets at the same time.
1. Press the PAGE button on the base. All handsets beep for two minutes,
and PAGING FROM BASE shows on each handset's display.
2. To cancel the page, press the PAGE button on the base, or press theTALK/
END/call back button or the *exit button on each handset.
33