Uconnect™ Voice Command - Jeep Wrangler User Manual

• Any voice commanded system should be used only in safe driving
conditions following local laws and phone use. All attention should
be kept on the roadway ahead. Failure to do so may result in a
collision causing you and others to be severely injured or killed.
• In an emergency, to use Uconnect™ Phone, your mobile phone must
be:
• turned on,
• paired to Uconnect™ Phone,
• and have network coverage.
Uconnect™ VOICE COMMAND
• The Uconnect™ Voice Command system allows you to control your AM,
FM radio, satellite radio, disc player, HDD, Uconnect™ Phone, a memo
recorder, and supported portable media devices.
• When you press the "Voice Command" button
radio faceplate or steering wheel, you will hear a beep. The beep is your
signal to give a command. If you do not say a command within a few
seconds, the system will present you with a list of options. If you ever
wish to interrupt the system while it lists options, press the "Voice
Command" button
Voice Command Operation
• Start a dialogue by pressing the
"Voice Command" button
you will hear a beep. The beep is
your signal to give a command.
Below are a list of voice
commands for each of the
different modes.
Common Voice Commands (Examples)
Main Menu
Radio Mode
ELECTRONICS
WARNING!
, listen for the BEEP, and say your command.
"Radio" (to switch to the radio mode)
"Disc" (to switch to the disc mode)
"Memo" (to switch to the memo recorder)
"System Setup" (to switch to system setup)
"Frequency" (to change the frequency)
"Next Station" (to select the next station)
"Previous Station" (to select the previous station)
"Radio Menu" (to switch to the radio menu)
"Main Menu" (to switch to the main menu)
,
located on the
71