Table 50.Error Register; Register Set - Hitachi T7K250 - Deskstar - Hard Drive Specifications

9.0 Registers

9.1 Register set

Table 46: Register Set
Addresses
CS0- CS1-
N N
N A
N A
N A
N A
A N
A N
A N
A N
A N
A N
A N
A N
A N
A N
A N
A N
A A
Logic conventions: A = signal asserted
* = Mapping of registers in LBA mode
Communication to or from the device is through an I/O Register that routes the input or output data to or from the
registers addressed by the signals from the host(CS0-, CS1-, DA2, DA1, DA0, DIOR- and DIOW-).
The Command Block Registers are used for sending commands to the device or posting status from the device.
The Control Block Registers are used for device control and to post alternate status.
DA2 DA1 DA0
x x x
0 x x
1 0 x
1 1 0
1 1 1
0 0 0
0 0 1
0 1 0
0 1 1
0 1 1
1 0 0
1 0 0
1 0 1
1 0 1
1 1 0
1 1 0
1 1 1
x x x
N = signal not asserted
x = either A or N
Deskstar T7K250 Hard Disk Drive Specification
Functions
READ (DIOR-)
Data bus high impedance
Control block registers
Data bus high impedance
Data bus high impedance
Alternate Status
Device Address
Command block registers
Data
Error Register
Sector Count
Sector Number
* LBA bits 0-7
Cylinder Low
* LBA bits 8-15
Cylinder High
* LBA bits 16-23
Device/Head.
* LBA bits 24-27
Status
Invalid address
71
WRITE (DIOW-)
Not used
Not used
Not used
Device Control
Not used
Data
Features
Sector Count
Sector Number
* LBA bits 0-7
Cylinder Low
* LBA bits 8-15
Cylinder High
* LBA bits 16-23
Device/Head
* LBA bits 24-27
Command
Invalid address