Alternate Status Register; Command Register; Cylinder High Register; Cylinder Low Register - Hitachi 7K80 - Deskstar - Hard Drive Specifications

9.2 Alternate Status Register

Table 55: Alternate Status Register
7 6
BSY RDY
This register contains the same information as the Status Register. The only difference between this register and the
Status Register is that reading the Alternate Status Register does not imply an interrupt acknowledge or a clear of a
pending interrupt. See section 9.14 'Status Register" on page 78 for the definition of the bits in this register.

9.3 Command Register

This register contains the command code being sent to the device. Command execution begins immediately after
this register is written. The command set is shown in Table 71: 'Command Set" on page 115 and Table
74: 'Command Set (2 of 2)" on page 106. All other registers required for the command must be set up before writ-
ing to the Command Register.

9.4 Cylinder High Register

This register contains the high order bits of the starting cylinder address for any disk access. At the end of the com-
mand, this register is updated to reflect the current cylinder number.
In LBA Mode this register contains Bits 16–23. At the end of the command, this register is updated to reflect the
current LBA Bits 16–23.
The cylinder number may be from zero to the number of cylinders minus one.
When 48-bit addressing commands are used, the "most recently written" content contains LBA Bits 16-23 and the
"previous content" contains Bits 40-47. The 48-bit Address feature set is described in Section 9.16, "48-Bit
Address Feature Set" on page 93.

9.5 Cylinder Low Register

This register contains the low order 8 bits of the starting cylinder address for any disk access. At the end of the
command, this register is updated to reflect the current cylinder number.
In LBA Mode this register contains Bits 8–15. At the end of the command, this register is updated to reflect the
current LBA Bits 8–15.
The cylinder number may be from zero to the number of cylinders minus one (1).
When 48-bit addressing commands are used, the "most recently written" content contains LBA Bits 8-15 and the
"previous content" contains Bits 32-39.
5 4 3
DSC/
DF DRQ
SERV
Deskstar 7K80 Hard Disk Drive Specification
2 1 0
COR IDX ERR
74