Table 40.Jumper Positions For Capacity Clip To 32Gb; Table 41.Jumper Settings For Disabling Auto Spin - Hitachi 7K80 - Deskstar - Hard Drive Specifications

7.1.4.3 Capacity clip to 32GB
The figure below shows the jumper positions used to select Device 0, Device 1, Cable Selection, or Device1
(Slave) Present while setting the drive capacity down to 32 GB for the purpose of compatibility.
Table 40: Jumper positions for capacity clip to 32GB
Note: The jumper setting acts as a 32GB clip which clips the LBA to 66055248. The CHS is unchanged from the
factory default of 16383/16/63.
7.1.4.4 Power up in Standby
The figure below shows the jumper positions used to select Device 0, Device 1, Cable Selection, or Device1
(Slave) Present to enable Power Up In Standby.
Table 41: Jumper settings for Disabling Auto Spin
I G E C
H F D
I
G E C
H F D
I G E C
H F D
I
G E C
H F D
I G E C
H F D
I
G E C
H F D
I G E C
H F D
I G E C
H F D
Deskstar 7K80 Hard Disk Drive Specification
A
DEVICE 0 (M aster)
B
A
DEVICE 1 (Slave)
B
A
CABLE SEL
B
A
DEVICE 1 (Slave) Present
B
A
DEVICE 0 (Master)
B
A
DEVICE 1 (Slave)
B
A
CABLE SEL
B
A
DEVICE 1 (Slave) Present
B
56