Instrument Panel Dimmer; Remote Start; High Beam; Panic Alarm - Jeep Liberty Quick Reference Manual

Key fob:
Locking and UnLocking the doors/Liftgate
• Press the LOCK button once to lock all doors and liftgate.
• Press the UNLOCK button once to unlock the driver's door only and
twice within five seconds to unlock all the doors and liftgate.
• All doors can be programmed to unlock on the first press of the
UNLOCK button.
• Press the liftgate flipper glass button
• Refer to the Owner's Manual for programming.

remote start

• Press the REMOTE START button
• To drive vehicle, press the UNLOCK button, insert the key in the ignition
and turn to ON/RUN position.
• With remote start, the engine will only run for 15 minutes (timeout) unless
the ignition key is placed in the ON/RUN position.
• The vehicle must be started with the key after two consecutive timeouts.

Panic aLarm

• Press the button once to turn the panic alarm on.
• Wait approximately three seconds and press the button a second time to
turn the panic alarm off.
twice within five seconds.
×
twice within five seconds.

fog lights

lights
Turn Signal/lighTS lever:
headLights/Parking Lights/aUtomatic headLights
• Rotate the end of the lever to the first detent for parking lights, the second
detent for headlights and the third detent for AUTO.
• When set to AUTO, the system automatically turns the headlights on or off
based on ambient light levels.

instrUment PaneL dimmer

• Rotate the center portion of the lever to the extreme bottom position to turn
off the interior lighting. In this position, the interior lights will not turn on
when a door is opened.
• Rotate the center portion of the lever up to increase the brightness of the
instrument panel lights when the parking lights or headlights are on.
• Rotate the center portion of the lever upward to the next detent position to
fully brighten the odometer and radio displays when the parking lights or
headlights are on.
• Rotate the center portion of the lever upward to the last detent to turn on
the interior lighting.

high Beam

• Push the lever forward to activate the high beams.
fog Lights
• Pull out the end of the lever. Fog lights only operate with parking lights or
low beam headlights.
tUrn signaLs/Lane change assist
• Tap the lever up or down once and the turn signal (right or left) will flash
three times then automatically turn off.
dimmer
push lever for
high beams