Kitchen Timer; Locking The Cooktop; Pan Detection Feature; Pan Sizing Feature - GE JP950 Owner's Manual

How to Lock the Cooktop
IMPORTANT: As a convenience, you
CONTROL CONTROL
LOCK LOCK
can lock the entire cooktop at any time
when it is not in use or before cleaning.
Locking the cooktop will prevent surface
elements from being turned on
accidentally.
To lock the cooktop:
Touch and hold the CONTROL LOCK pad
for 3 seconds.
A two-beep signal will sound, the word
"LOCK" will appear in the TIMER display,
How to Operate the Kitchen Timer
ON
NOTE: The kitchen timer will NOT turn off the
OFF
surface elements when the time reaches 00:00.
TIMER
To operate the kitchen timer, use the
pads below the TIMER display.
OR
Touch the ON/OFF pad and then
touch the (+)/(-) pad to choose the
desired time setting. If the (+)/(-) pad is
held for several seconds, the timer will
increase or decrease at a faster rate.
Using the Pan Detection Feature
PAN
This feature automatically turns off a
surface element after 60 seconds if a pan
is absent from the surface element. The
power level display will flash until the
surface element automatically turns off
when the control detects the absence
of a pan.
To activate and deactivate pan detection for
all surface elements:
Touch the PAN pad. (At least one surface
element must be on.) The display will
flash "PAN ON" when the pan detection
feature is on.
A signal will sound and a light next to
the PAN pad will indicate whether the
feature is active. If the light is on, pan
Using Pan Sizing
PAN
This feature is only used on the dual
surface element when the pan detection
feature is enabled. When a small pan is
placed on the surface element, the small
surface element will activate. When a pan
larger than 6.0 inches is placed on the
surface element, the large surface
element will automatically activate. This
feature may be overridden for a single
cooking session while leaving the pan
detection feature active (see Dual Surface
Element section).
www.GEAppliances.com
and the Control Lock light will turn on,
indicating that the cooktop is locked.
If the cooktop is locked while the surface
elements or timer are in use, they will
automatically turn off.
To unlock:
Touch and hold the CONTROL LOCK pad
again for 3 seconds.
A two-beep signal will sound, and the
Control Lock light will go out, indicating
that the cooktop is unlocked.
After you have chosen your desired time,
the timer will automatically start to count
down from the hours/minutes that you
have selected. After the timer counts
down to the last minute, it will count
down in seconds until 00:00. After the
time has run out, the control will beep
twice every five seconds until the timer is
turned off. Touch the ON/OFF pad to turn
the timer off.
detection is on, and if the light is off,
pan detection is off. When the pan
detection feature is disabled, the pan
sizing feature is also disabled.
NOTES:
s
For this feature to work properly, the
pan diameter must be greater than 4.0
inches and centered on the surface
element.
s
This feature may not operate properly
with rounded, curved or warped pan
bottoms (see the Types of Cookware
section).
s
This feature will not work with
glass-ceramic/stoneware cookware
(see the Types of Cookware section).
To turn off this feature and the pan detection
feature:
Touch the PAN pad.
The light next to the pad will go out,
indicating that pan features are turned off.
NOTE: The pan must be centered over the
surface element for this feature to work properly.
9