Clarke Little Devil II (inc ss) Operation & Maintenance Instructions Manual
Clarke Little Devil II (inc ss) Operation & Maintenance Instructions Manual

Clarke Little Devil II (inc ss) Operation & Maintenance Instructions Manual

Advertisement

Quick Links

GAS HEATER
Model No: Little Devil II (inc ss)
PART NO: 6926020, 6926025 (SS)
OPERATION & MAINTENANCE
INSTRUCTIONS
LS0813

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Little Devil II (inc ss) and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Clarke Little Devil II (inc ss)

  • Page 1 GAS HEATER Model No: Little Devil II (inc ss) PART NO: 6926020, 6926025 (SS) OPERATION & MAINTENANCE INSTRUCTIONS LS0813...
  • Page 2 This guarantee does not effect your statutory rights. UNPACKING When unpacking, check the heater for possible shipping damage. Should any damage be apparent, please notify your Clarke dealer immediately. Your heater is fully assembled,- only the electrical and gas supplies need connecting.
  • Page 3: General Safety Precautions

    GENERAL SAFETY PRECAUTIONS 12. Check the heater for damage Read, and make sure you fully before each use. Do not use a understand the following precautions damaged heater. and the hazards associated with this type of equipment. 13. Check the hose before each use of the heater.
  • Page 4: Minimum Clearances From Combustibles

    MINIMUM CLEARANCES FROM COMBUSTIBLES Outlet 6 Ft. (1.83 m) 6 Ft. (1.83 m) Sides 6 Ft. (1.83 m) Rear 2 Ft. (0.61 m) RISKS OF CARBON MONOXIDE POISONING Even though this heater operates very close to 100 percent combustion efficiency, it still produces small amounts of carbon monoxide. •...
  • Page 5: Electrical Connections

    ELECTRICAL CONNECTIONS WARNING: READ THESE ELECTRICAL SAFETY INSTRUCTIONS THOROUGHLY BEFORE CONNECTING THE PRODUCT TO THE MAINS SUPPLY. Connect the mains lead to a standard, 230 Volt (50Hz) electrical supply through an approved BS1363/A plug fitted with a BS1362 3 amp fuse. If the plug has to be changed because of damage, it must be removed and a replacement fitted, following the wiring instructions shown below.
  • Page 6: Theory Of Operation

    THEORY OF OPERATION THE FUEL SYSTEM: The hose/regulator assembly attaches to the propane gas supply. This provides fuel to the heater. THE AIR SYSTEM: The motor turns the fan. The fan pushes air into and around the combustion chamber. This air is heated and provides a stream of clean, hot air.
  • Page 7: Propane Gas Supply

    PROPANE GAS SUPPLY WARNING: THE FITTING AND CHANGING OF THE GAS CYLINDERS MUST BE CARRIED OUT IN A FLAME FREE ATMOSPHERE. WARNING: YOU SHOULD ONLY USE PROPANE GAS CYLINDERS AVAILABLE FROM BUILDERS MERCHANTS OR GAS SUPPLIERS. This range of portable, direct fired gas heaters is designed to give safe, efficient and reliable operation, and are for use with propane gas only.
  • Page 8: Installation

    INSTALLATION WARNING: READ AND UNDERSTAND THE WARNINGS IN THE SAFETY INFORMATION SECTION, PAGE 3. THEY ARE NEEDED TO SAFELY OPERATE THIS HEATER. FOLLOW ALL LOCAL REGULATIONS WHEN USING THIS HEATER. WARNING: TEST ALL GAS PIPING AND CONNECTIONS FOR LEAKS AFTER INSTALLATION OR SERVICING.
  • Page 9: Starting Procedure

    VENTILATION WARNING: PROVIDE AT LEAST A 1.5 FT (1400 CM ) OPENING OF FRESH, OUTSIDE AIR WHILE RUNNING HEATER. IF PROPER FRESH, OUTSIDE AIR VENTILATION IS NOT PROVIDED, CARBON MONOXIDE POISONING CAN OCCUR. PROVIDE PROPER FRESH, OUTSIDE AIR VENTILATION BEFORE RUNNING HEATER.
  • Page 10: Stopping Procedure

    6. Push in and hold the automatic control valve button. 7. Push the piezo ignitor button. • You may need to push the piezo ignitor button 3-8 times until the burner lights. • When the burner lights, keep the automatic control valve button pushed in.
  • Page 11: Maintenance

    STORAGE CAUTION: DISCONNECT THE HEATER FROM PROPANE SUPPLY TANK(S) Store propane tank(s) in safe manner. • Follow all local regulations. • Always store propane tanks outdoors. Place plastic cover caps over any brass fittings, the connector and hose/ regulator assembly. Store in a dry, clean and safe...
  • Page 12: Troubleshooting

    TROUBLESHOOTING WARNING: NEVER SERVICE THE HEATER WHILE IT IS PLUGGED CONNECTED TO PROPANE SUPPLY, OPERATING OR HOT. SEVERE BURNS AND ELECTRICAL SHOCK CAN OCCUR. OBSERVED FAULT POSSIBLE CAUSE REMEDY Fan does not No electrical power to the Check voltage to turn when heater electrical outlet.
  • Page 13: Specifications

    OBSERVED FAULT POSSIBLE CAUSE REMEDY Heater shuts High surrounding air This can happen when down while temperature causing running heater in running thermal limit device to temperatures above 85 shut down heater Only run the heater in cooler temperatures Restricted air flow Check heater inlet and outlet.
  • Page 14: Parts Diagram

    PARTS DIAGRAM Grill Assembly GFLDEV201 Middle Cylinder Assembly GFLDEV214 Motor Mounting Bracket GFLDEV202 Power Cord GFLDEV215 Motor Assembly GFLDEV203 On/off Switch GFLDEV216 Screw,45# 1/4"-28*1/3 GFLDEV204 Hose/regulator Assembly GFLDEV217 GFLDEV205 Regulator Connector GFLDEV218 Thermal Switch Kit GFLDEV206 Air Tube GFLDEV219 Burner Tube Part 2 GFLDEV207 Piezo Ignitor GFLDEV220...
  • Page 15: Declaration Of Conformity

    DECLARATION OF CONFORMITY Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com...

This manual is also suitable for:

Little devil ii

Table of Contents