EnGenius EAP350 Manual page 38

37
Wireless Advanced
Data Rate Select a data rate from the drop-down list. The data rate affects throughput. If you select a low
data rate value, the throughput is reduced but the transmission distance increased.
Transmit Power Set desired output power of the wireless signal.
RTS/CTS Threshold Specify the threshold package size for RTC/CTS. A smaller number causes RTS/CTS packets to be
sent more often and consumes more bandwidth.
Distance
Specify the distance between Access Points and clients. Longer distances may reduce high-speed
connections.
Short GI Sets the time that the receiver waits for RF reflections to settle out before sampling data. Using a
short (400ns) guard interval can increase throughput, but it can also increase error rate in some
installations due to increased sensitivity to radio-frequency reflections. Select the option that
works best for your installation.
Aggregation
Merges data packets into one packet. This option reduces the number of packets, but increases
packet sizes.
Wireless Traffic Check this option to enable wireless traffic shaping. Traffic shaping regulates the flow of packets
Shaping
leaving an interface to deliver improved Quality of Service.
Incoming Traffic Limit Specify the wireless transmission speed used for downloading.
Outgoing Traffic Limit Specify the wireless transmission speed used for uploading.
Accept / Cancel Click [Accept] to confirm the changes or [Cancel] to cancel and return previous settings.