Table of Contents
Advertisement
Bosch Video Management System
Notice!
When you open such an exported CSV file in Microsoft Excel, it can happen that time related
i
cells do not display seconds.
To change this behavior, change the formatting of these cells from m/d/yyyy h:mm to m/d/
yyyy h:mm:ss
11.11
Options dialog box
Failover VRM
Select to enable retrieving recordings from the Failover VRM.
Main window > Extras menu > Options... command
Allows you to configure parameters for using Bosch Video Management System.
Control tab
Dwell time for automatic sequences [s]:
Enter the required number of seconds a camera is to be displayed in an Image pane. This time
is also valid for alarm sequences.
PTZ Control Speed
Move the slider to adjust the control speed for PTZ cameras.
Rewind time of instant playback [s]:
Enter the amount of seconds for the rewind time of instant playback.
Display the map containing the camera of the selected Image pane
Click to activate that the map of the camera in the selected Image pane is getting the focus.
The map is displayed in the Map window of the Control monitor. If the selected camera is not
configured on any map, the Map window is cleared.
The displayed map is the first found map in the Logical Tree beginning from the root item, that
contains the selected camera.
If a camera sequence is running within the selected Image pane, after each sequence step the
map in the Map window is updated accordingly.
Display tab
Image pane aspect ratio
For each connected monitor select the required aspect ratio for the Image panes in Operator
Client. Use 16:9 for HD cameras. This setting overrides the setting that was made in
Configuration Client for the initial startup of Operator Client.
Display Logical Number
Select to display the logical number of a camera in the Logical Tree.
Audio tab
Playback audio of the selected Image pane
Select to activate audio playback for the video in the selected Image pane.
Multichannel audio playback
Select to enable simultaneous audio playback for all videos displayed in the Image panes.
Alarm and event sound volume:
Move the slider to adjust the sound volume of alarm sounds.
Half Duplex
Select to enable half duplex mode for the Intercom functionality.
Full Duplex
Select to enable full duplex mode for the Intercom functionality.
Bosch Sicherheitssysteme GmbH
Operator's Manual
User interface | en
55
2012.07 | V1 | Operation Client
Advertisement
Table of Contents
