Alcove Or Closet Installation; Washer Connections For - GE WSLP1500 Owner's Manual & Installation Instructions

WASHER CONNECTIONS FOR STATIONARY MODEL WSLS1500
6 INSTALLATION CHECKLIST
Before starting the washer, check to make sure:
❏ Main power is turned on.
❏ The washer is plugged in.
❏ The water faucets are turned on.
❏ The unit is level.
❏ The drain hose is properly tied up.
❏ There are no leaks at the faucet, drain line
or washer.
RUN THE WASHER THROUGH A
7
COMPLETE CYCLE
Check for water leaks and proper operation.

ALCOVE OR CLOSET INSTALLATION

If your washer is approved for installation in an alcove or
closet, there will be a label on the back of the machine
describing requirements.
• Minimum clearances between washer and adjacent
walls or other surfaces are: 0" either side, 2" front,
3" rear.
• Minimum vertical space from floor to overhead
shelves, cabinets, ceilings, etc. is 96" .
• Closet doors must be louvered or otherwise ventilated
and have at least 60 square inches open area for
washer only, or if the closet contains both a washer
and dryer, doors must contain at least 120 square
inches of open area equally distributed.
NOTE: The clearances stated on this label are minimums.
Consideration must be given to providing adequate
clearances for installation and servicing.
12
Installation Instructions
8 REMOVE THE PROTECTIVE FILM
COVERING THE CONTROL PANEL
9 READ THE REST OF THIS OWNER'S
MANUAL
It contains valuable and helpful information that will save
you time and money.
NOTE: If your washer does not operate, please review
the Before You Call For Service section.
Closet door
60 sq. in.
(387.1 sq. cm)
60 sq. in.
(387.1 sq. cm)