Mobile Home Installation; Alcove Or Closet Installation - GE Spacemaker WSM2780 Gas Installation Instructions Manual

EXHAUST (CONT.)
SEALING OF JOINTS
• All joints should be tight to avoid leaks.
NOTE:
The male end of each section of duct must point
away from the dryer.
• Do not assemble ductwork with fasteners that
extend into the duct. They will serve as a collection
point for lint.
• Duct joints can be made air- and moisture-tight by
wrapping the overlapped joints with duct tape.
INSULATION
• Ductwork that runs through an unheated area or is
near an air conditioning duct should be insulated to
reduce condensation and lint buildup.
PARTS AVAILABLE FROM LOCAL SERVICE
ORGANIZATIONS
• Rigid Metal Duct Components
WX8X63 4" x 1' Duct
WX8X64 4" x 2' Duct
WX8X51 4" Elbow
WX8X59 4" Aluminum Hood
• Flexible Metal Duct Components
Kit WX8X66—7' Aluminum duct, 4" hood and 2 clamps
WX8X65 7' Aluminum Flexible Duct
WX8X58 4" Clamps (2)
WX8X59 4" Aluminum Hood
Installation Instructions
7

MOBILE HOME INSTALLATION

• Installation must conform to Manufactured Home
Construction and Safety Standard, Title 24 CFR,
Part 32-80.
• The dryer must be exhausted to the outside with
the termination securely fastened to the mobile
home structure.
• The exhaust MUST NOT be terminated beneath the
mobile home.
• The exhaust duct material MUST NOT support
combustion.
CONSIDERATION MUST BE GIVEN TO PROVIDE ADEQUATE
CLEARANCES FOR INSTALLATION AND SERVICE.

ALCOVE OR CLOSET INSTALLATION

1" 0"
60 Sq. In.
60 Sq. In.
• If your dryer is approved for installation in an alcove
or closet, it will be stated on a label on the back of
the dryer.
• TO PREVENT LARGE AMOUNTS OF LINT AND MOISTURE
FROM ACCUMULATING AND TO MAINTAIN DRYING
EFFICIENCY, THIS MACHINE MUST BE EXHAUSTED
OUTDOORS.
• DO NOT install this appliance with less than
the minimum clearances shown above.
CONSIDERATION MUST BE GIVEN TO PROVIDE ADEQUATE
CLEARANCES FOR INSTALLATION AND SERVICE.
CAUTION: DO NOT INSTALL THIS APPLIANCE IN A CLOSET
WITH A SOLID DOOR.
0"
0"
1"