Weslo Cadence 21.5 Treadmill Manual page 8

3. Set the console assembly face down on a soft
surface to avoid scratching it.
Identify the Right Handrail (6), which has a
large hole in the location shown. Hold the Right
Handrail near the console assembly.
Next, insert the console wire into the large
hole in the side of the Right Handrail (6). Using
needlenose pliers, carefully grasp the connector
and pull the console wire out of the hole near the
bracket on the Right Handrail.
4. Set the Right Handrail (6) on the console assem-
bly. Make sure that the console wire is not
pinched.
Start an M5 x 16mm Screw (89) with an M5 Star
Washer (90) into the Right Handrail (6), and then
start two M4.2 x 19mm Screws (3) into the Right
Handrail. Tighten the M5 x 16mm Screw and
then tighten the two M4.2 x 19mm Screws; do
not overtighten the Screws.
Attach the Left Handrail (not shown) to the
console assembly in the same way. Note:
There is not a wire on the left side.
3
Console Wire
Bracket
Console
Assembly
4
Console Wire
Bracket
Console
Assembly
8
Connector
Large
Hole
6
Wire Tie
89
90
6
3