Troubleshooting - Weslo Cadence 21.5 Treadmill Manual

TROUBLESHOOTING

Most treadmill problems can be solved by fol-
lowing the steps below. Find the symptom that
applies, and follow the steps listed. If further assis-
tance is needed, please see the front cover of this
manual.
SYMPTOM: The power does not turn on
a. Make sure that the power cord is plugged into
a properly earthed outlet (see page 12). If an
extension cord is needed, use only a 3-conductor,
14-gauge (1 mm ) cord that is no longer than 5 ft.
2
(1.5 m).
b. After the power cord has been plugged in, make
sure that the key is inserted into the console.
c. Check the power switch located on the treadmill
frame near the power cord. If the switch protrudes
as shown, the switch has tripped. To reset the
switch, wait for five minutes and then press the
switch back in.
c
Tripped
SYMPTOM: The power turns off during use
a. Check the power switch (see the drawing above).
If the switch has tripped, wait for five minutes and
then press the switch back in.
b. Make sure that the power cord is plugged in.
c. Remove the key from the console. Reinsert the key
into the console.
Reset
18
d. If the treadmill still will not run, please see the front
cover of this manual.
SYMPTOM: the displays of the console do not
function properly
a. Remove the key from the console and UNPLUG
THE POWER CORD. Place the treadmill in
the storage position (see HOW TO FOLD THE
TREADMILL on page 17).
Remove the six indicated M4.2 x 13mm Washer
Head Screws (5) and the six Foot Rail Flat
Washers (25). Next, lower the Frame (50) (see
HOW TO LOWER THE TREADMILL FOR USE on
page 17).
a
5
25
5
50
5
25
5