Assembly - Weslo Cadence 21.5 Treadmill Manual

ASSEMBLY

•• Assembly requires two persons.
•• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you  nish all assembly steps.
•• After shipping, there may be an oily substance
on the exterior of the treadmill. This is normal. If
there is an oily substance on the treadmill, wipe
it off with a soft cloth and a mild, non-abrasive
cleaner.
•• Left parts are marked “"L”" or “"Left”" and right parts
are marked “"R”" or “"Right.”"
1. Go to www.iconsupport.eu on your computer
and register your product.
•• activates your warranty
•• saves you time if you ever need to contact
Customer Service
•• allows us to notify you of upgrades and offers
Note: If you do not have Internet access, call
Customer Service (see the front cover of this
manual) and register your product.
2. Make sure that the power cord is unplugged.
With the help of a second person, carefully tip
the treadmill onto its left side. Unfold the Frame
(50) away from the Uprights (73, 10). Do not
lean on the Uprights.
Orient the Base (80) as shown. Attach the Base
to the Uprights (73, 10) with four M10 x 65mm
Screws (1). Start all four Screws, and then
tighten each of them.
Raise the Uprights (73, 10), so that the Base
(80) is flat on the floor.
•• To identify small parts, see page 6.
•• Assembly requires the following tools:
the included hex keys
one Phillips screwdriver
needlenose pliers
To avoid damaging parts, do not use power tools.
1
2
10
50
7
80
1
73
1