Switching Off The Engine; Parking Brake; Indicator Lamp; Manual Transmission - BMW 328i xDrive Owner's Manual

3 series
Hide thumbs Also See for 328i xDrive:
Table of Contents

Advertisement

Switching off the engine

Always take the remote control with you
when you leave the vehicle.
When parking, apply the parking brake force-
fully; otherwise, the vehicle could begin to

Manual transmission

1.
With the car at a standstill, press the Start/
Stop button.
2.
Shift into first gear or reverse.
3.
Forcefully apply the parking brake.
4.
Removing the remote control from the igni-
tion lock, refer to page 61.
Automatic transmission
1.
With the car at a standstill, move the selec-
tor lever to position P.
2.
Press the Start/Stop button.
3.
Forcefully apply the parking brake.
4.
Removing the remote control from the igni-
tion lock, refer to page 61.
Sport automatic transmission with
double clutch
1.
With the car at a standstill, press the Start/
Stop button.
If the transmission is shifted into N when the
engine is switched off, you will be notified
visually and acoustically of this fact.
2.
Forcefully apply the parking brake.
3.
Remove remote control from the ignition
lock, refer to page 61. The transmission is
automatically shifted into transmission
position P.
Online Edition for Part no. 01 40 2 609 333 - © 08/11 BMW AG

Parking brake

The parking brake is primarily intended to pre-
vent the vehicle from rolling while parked; it
brakes the rear wheels.
roll.<

Indicator lamp

The indicator lamp is lit, and when you
drive off an acoustic signal sounds in
addition. The parking brake is still
applied.
Indicator lamp for Canadian models.
Applying
The lever locks in position automatically.
Releasing
Pull slightly upwards, press the button and
lower the lever.
In exceptional cases, if the parking brake
has to be used to slow or stop the car, do
not pull the lever up too hard. In doing so, con-
tinuously press the button of the parking brake
lever.
Otherwise, excessive force on the parking
brake can lock up the rear wheels and cause the
rear of the car to
To prevent corrosion and one-sided brak-
ing action, occasionally apply the parking
brake lightly when the vehicle is slowly coming
to a stop if the traffic conditions are suitable.
The brake lamps do not light up when the park-
ing brake is
Driving
Controls
swerve.<
applied.<
63

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

335i xdriveM3335is

Table of Contents