BMW 328i xDrive Owner's Manual page 262

Display in the instrument cluster
1. Push button 1 in the turn signal/high beam
lever up or down repeatedly until the appro-
priate symbol is shown in the display,
accompanied by the word "OIL".
Press button 2 in the turn signal/high beam
2.
lever.
The oil level is checked and the reading dis-
played.
Possible displays
1 Oil level OK
2
Oil level is being checked.
This can take about 3 minutes if the car is at
a standstill on a level surface, or about
5 minutes while the car is on the move.
Online Edition for Part no. 01 40 2 609 333 - © 08/11 BMW AG
Engine compartment
3 Oil level down to minimum:
Add engine oil as soon as possible, but no
more than 1 US quart/1 liter, refer also to
Adding engine oil on page 262.
4
Oil level is too high.
Too much oil will harm the engine.
Have the vehicle checked without
delay.<
5 The oil level sensor is defective.
Do not add engine oil. You can continue
your journey. Note the newly calculated dis-
tance remaining to the next oil service, refer
to page 87. Have the system checked as
soon as possible.
Display via iDrive
1. "Vehicle Info"
2. "Vehicle status"
3. "Engine oil level"
Possible messages
>
"Engine oil level OK"
> "Measurement not possible at this time."
Mobility
261