Parking Brake; Switching Off The Engine - BMW 2006 Z4 3.0i2006 Z4 3.0si Owner's Manual

Automatic transmission
1. Depress the brake.
2. Start the engine.
Special starting conditions
In the following situations, press the accelerator
pedal halfway down when starting the engine:
> If the engine does not start on the first
attempt, for instance when it is extremely
hot or cold.
> If the engine is started at very low tempera-
tures, below approx. +5 7/–156, at high
altitudes above approx. 3,300 ft/1,000 m.
Avoid frequent starting attempts in quick
succession or repeated starting attempts
during which the engine does not start. Other-
wise, the fuel is not burned or inadequately
burned; there is a danger of overheating and
damaging the catalytic

Switching off the engine

Do not remove the key while the vehicle is
still moving. Otherwise, the steering lock
would engage when the steering wheel is
turned.
When you leave the vehicle, always remove the
key and engage the steering lock.
Apply the parking brake when parking on steep
gradients, otherwise the vehicle could start to
roll.<
You can have an acoustic signal set as a
reminder that the key is still in the ignition
switch after the driver's door has been
opened.<
Manual transmission
1. Turn the key to position 1 or 0.
2. Engage first gear or reverse gear.
3. Apply the handbrake.
Automatic transmission
1. With the car at a standstill, move the selec-
tor lever to position P.
2. Turn the key to position 1 or 0.
Online Edition for Part-No. 01 41 0 012 083 - © 04/06 BMW AG
converter.<

Parking brake

The parking brake is designed primarily to pre-
vent the vehicle from rolling when parked. It
operates against the rear wheels.
Indicator lamp
The indicator lamp is lit, and when you
drive off a signal sounds in addition.
The handbrake is still applied.
Indicator lamp for Canadian models.
Applying
The lever locks in position automatically.
Releasing
Pull slightly upwards, press the button and
lower the lever.
If, in exceptional circumstances, it should
be necessary to engage the parking brake
while the vehicle is in motion, do not pull it with
excessive pressure. In doing so, continuously
press the button of the handbrake lever. Other-
wise, too violent an application of the hand-
brake can overbrake the rear axle and cause the
rear of the car to swerve.<
To prevent corrosion and one-sided brak-
ing action, occasionally apply the hand-
brake lightly when the vehicle is slowly coming
to a stop if the traffic conditions are suitable.
The brake lamps do not light up when the hand-
brake is applied.<
39