Download  Print this page

Honeywell CT3300 Installation And Programming Instructions page 3

Weekday/weekend (5-day/2-day) programmable heat and/or cool low voltage (20 to 30 vac) thermostat and mounting plate
Hide thumbs

Advertisement

Steam
A steam boiler with radiator heat.
Heat Pump
Heating and cooling are produced from the same outdoor unit (compressor) with
no auxiliary or backup heat.
Multistage Heat Pump
Heating and cooling are produced from the same outdoor unit (compressor) with
auxiliary or backup heat.
Multistage Conventional
A heating or cooling system with more than one stage.
Step 1. Prepare for Installation
1.
Carefully unpack your new thermostat. Save your receipt and make sure you have the following parts:
Thermostat and mounting plate.
Labels.
Screws and anchors.
Installation and Programming Instructions.
2.
Gather the needed tools and supplies listed below.
Required Tools and Supplies
Two AA alkaline batteries. Honeywell recommends Energizer®
batteries.
Screwdriver.
Hand or power drill with 3/16-inch or 7/32-inch drill bit.
Pencil.
3.
Make sure that your heating and cooling systems are working correctly. If there is a problem with either system,
call a heating/air conditioning contractor—the problem may persist after you install the new thermostat.
IMPORTANT:
To avoid damaging the compressor in the air conditioner, do not operate the cooling system when the tem-
perature outdoors is below 50°F (10°C).
Heating/Cooling System
Wire cutter/stripper or sharp knife.
Level.
Electrical tape.
3
Compatible
with CT3300?
Alternate Model
No
CT3600
No
CT3600
No
CT3611
No
See your
contractor
Optional Tools
69-1634—1

Advertisement

loading

  Related Manuals for Honeywell CT3300