Mobile Home Installation - GE Spacemaker DH43 Owner's Manual And Installation Instructions

MOBILE HOME INSTALLATION

1. Dryer MUST be exhausted outside (outdoors, not
beneath the mobile home) using metal ducting that will
not support combustion. Metal ducting must be 4
(10.16 cm) in diameter with no obstructions. Rigid metal
duct is preferred.
2. If dryer is exhausted through the floor and area beneath
the mobile home is enclosed, the exhaust system MUST
terminate outside the enclosure with the termination
securely fastened to the mobile home structure.
3. When installing a gas dryer into a mobile home, a
provision must be made for outside make-up air. This
provision is to be not less than twice the area of the dryer
exhaust outlet.
4. A gas dryer MUST be fastened to the floor. Mobile
Home Installation Kit Pub. No. 14–D346–33 is available
from your dealer.
5. See the Exhaust System Requirements section for other
important venting information.
6. Installation MUST conform to current Manufactured
Home Construction & Safety Standard (which is a
Federal Regulation Title 24 CFR—Part 32–80) or,
when such standard is not applicable, with American
National Standard for Mobile Homes. In Canada, the
CSA Z240 is applicable.
Correct
Incorrect
Don't
Don't
The dryer is designed under ANSI Z 21.5.1 for HOME
USE only.
Installation Instructions
Do
Don't
15
ROUGH-IN DIMENSIONS
26 7/8
(68.3 cm)
Electrical connection
2 9/16
(6.5 cm)
13 1/2
(34.4 cm)
3/8 (0.96 cm) Dia.
gas pipe
3 3/4
(9.5 cm)
REAR VIEW
47 1/2
(120.7 cm)
3/4
(1.9 cm)
Door open
90˚
vent knockout
SIDE VIEW
SERVICING—Consideration must be given to provide
adequate clearances for installation and servicing.
CAUTION—Label all wires prior to disconnection
when servicing controls. Wiring errors can cause
improper and dangerous operation (verify proper
operation after servicing/installation).
Under
counter
34 5/8
(87.9 cm)
36
(91.5 cm)
1 (2.54 cm)
4 3/8
(11.1 cm)
Optional
27
(68.6 cm)
3 3/4
(9.5 cm)