GE Spacemaker DH43 Owner's Manual And Installation Instructions page 18

GAS CONNECTION FOR
GAS DRYERS
1. Remove the shipping cap from gas pipe at the rear of the
dryer.
Conversion to LP Gas: DO NOT connect the dryer to LP
gas service without converting the gas valve. An LP
conversion kit (Pub. No. 14–A038) MUST be installed by a
qualified gas technician.
a. Connect a 1/2 (1.27 cm) I.D. semi-rigid
or approved pipe from gas supply line to
the 3/8 (0.96 cm) pipe located on the back of the
dryer. Use a 1/2 to 3/8 (1.27 cm to 0.96 cm)
reducer for a connection. Apply an approved thread
sealer that is resistant to the corrosive action of
liquefied gases on all pipe connections.
b. Open the shutoff valve in the gas supply line.
c. Test all connections by brushing on a soapy water
solution.
CAUTION: NEVER TEST FOR GAS
LEAKS WITH AN OPEN FLAME.
2. Connect the exhaust duct to outside exhaust system.
Use duct tape to seal all joints.
3. With the dryer in its final position, adjust one or more of
the legs until the dryer is resting solidly on all four legs.
Place a level on top of the dryer. THE DRYER MUST
BE LEVEL AND RESTING SOLIDLY ON ALL FOUR
LEGS. Turn the lock nuts on each of the four legs up
toward the base of the dryer and snug with a 1/2 open-
end wrench.
4. Plug the power cord into a grounded outlet.
NOTE: Check to ensure the power is off at circuit
breaker/fuse box before plugging the power cord
into the outlet.
5. Turn on the power at the circuit breaker/fuse box.
Installation Instructions
18
CAUTION: Before operating the dryer, make sure
the dryer area is clear and free from combustible
materials, gasoline, and other flammable vapors.
Also see that nothing (such as boxes, clothing, etc.)
obstructs the flow of combustion and ventilation air.
6. Run the dryer through a cycle check for proper
operation.
NOTE: On gas dryers, before the burner will light, it is
necessary for the gas line to be bled of air. If the burner
does not light within 45 seconds the first time the dryer is
turned on, the safety switch will shut the burner off. If this
happens, turn the timer to OFF and wait 5 minutes before
making another attempt to light.
7. If your dryer does not operate, please review the
Troubleshooting Tips section in this manual before
calling for service.
8. Place these instructions in a location near the dryer for
future reference.