Canon PIXMA iP6600D Service Manual page 20

QM2-2313
PR lift shaft ass'y
QL2-0936
Timing slit strip film
QC1-6394
Timing slit disk film
QC1-6229
Print head
QY6-0063
LCD viewer unit
QM2-2305
Panel board ass'y
QM2-2747
*1: General notes:
- Make sure that the flexible cables and wires in the harness are in the proper position and connected correctly.
[See 3-2. Special Notes on Repair Servicing, (2) Flexible cable and harness wiring, connection, for details.]
- Do not drop the ferrite core, which may cause damage.
- Protect electrical parts from damage due to static electricity.
- Before removing a unit, after removing the power cord, allow the printer to sit for approx. 1 minute (for
capacitor discharging to protect the logic board ass'y from damages).
- Do not touch the timing slit strip film and timing slit disk film. No grease or abrasion is allowed.
- Protect the units from soiled with ink.
- Protect the housing from scratches.
- Exercise caution with the red screws, as follows:
i. The red screws of the paper feed motor may be loosened only at replacement of the paper feed motor
unit (DO NOT loosen them in other cases).
ii. DO NOT loosen the red screws on both sides of the main chassis, securing the carriage shaft
positioning (they are not adjustable in servicing).
To the table of contents
- Upon contact with the film,
wipe the film with ethanol.
- Confirm no grease is on the
film. (Wipe off any grease
thoroughly with ethanol.)
- Do not bend the film
<Part 1: 3. REPAIR, 3-1>
1. Check the ink system
function.
[See 3.3. Adjustment /
Settings, (5) Service mode.]
At replacement:
1. Apply grease to the
sliding portions.
[See 3.3. Adjustment /
Settings, (2) Grease
application.]
After replacement:
1. Perform the print head
alignment in the user
mode.
After replacement:
1. Perform the print head
alignment in the user
mode.
1-14
- Service test print
- Service test print
- Service test print
- Button and LCD test (in
the service mode)
To the top