IP Camera 200 Series
3
Installation
3.1
Disassembly
The camera/housing unit consists of the following parts:
1.
2.
3.
To disassemble the unit proceed as follows:
1.
2.
3.
Bosch Security Systems
x2
Dome
Inner liner
Camera module and mounting base
Using the special screwdriver bit supplied, loosen the two
tamper-resistant screws in the dome (the screws remain in
place).
Remove the dome from the base.
Remove the inner liner by pulling it off the base.
Installation and Operation Manual
Installation | en
AR18-10-B012 | v1.5 | 2011.01
15