Programming Input Names; Assigning Record Outputs - Mark Levinson 380 Owner's Manual

programming
input names
24

assigning record outputs

To change the name of any particular input, follow these steps:
1 In the Monitor Mode, Select the input you wish to rename
2 press and hold the Mode button...
on the front panel until the display reads SET DATA, as below:
3 Release the Mode button; Press the chosen Input button re-
peatedly...
until the Name you desire appears in the display.
4 press and hold the Mode button again...
until the display reads
Step 5 below if you have selected an name of a device capable of re-
cording.) This indicates that your new name for that input has
been stored in nonvolatile memory. As a result, this new setting
will survive power outages and other interruptions of AC power
to the preamp.
5 If the source in question is a recordable device...
You will be further prompted to associate a particular
with this particular device. Instead of showing "
put
the display will read "
, as shown below. (Note: see
NEW DATA
" as shown below.
RCD: NONE
record out-
,"
NEW DATA