Subscribe to Our Youtube Channel
Related Manuals for Manley Purist
Summary of Contents for Manley Purist
- Page 1 MANLEY LABORATORIES, INC. OWNER'S MANUAL THE PURIST PREAMPLIFIER MANLEY LABORATORIES, INC. 13880 MAGNOLIA AVE. CHINO, CA. 91710 TEL: (909) 627-4256 FAX: (909) 628-2482 email: emanley@netcom.com http://www.manleylabs.com...
-
Page 2: Table Of Contents
CONTENTS SECTION PAGE INTRODUCTION MAINS CONNECTIONS CONNECTING YOUR PREAMPLIFIER FIGURE 1 FRONT PANEL FIGURE 2 REAR PANEL OPERATIONAL NOTES SPECIFICATIONS WARRANTY WARRANTY REGISTRATION... -
Page 3: Introduction
GENERAL NOTES LOCATION & VENTILATION The Purist Preamplifier must be installed in a stable location with ample ventilation. It is recommended, if this unit is rack mounted, that you allow enough clearance on the top and bottom of the preamp such that a constant flow of air can flow through the ventilation slots. -
Page 4: Mains Connections
MAINS CONNECTIONS Your preamplifier has been factory set to the correct mains voltage for your country. The voltage setting is marked on the serial badge, located on the rear panel. Check that this com- plies with your local supply. Export units for certain markets have a moulded mains plug fitted to comply with local require- ments. -
Page 5: Connecting Your Preamplifier
CONNECTING YOUR PREAMPLIFIER Setting up your preamplifier is rather easy. 1. Please refer to page 7 diagram 2 for an illustration of the back of the preamplifier. 2. There are three sets of main outputs, two identical sets of UNBALANCED RCA and the other BALANCED XLR. -
Page 6: Front Panel
VOLUME SELECT SET GAIN OPERATE HIGH TAPE MANLEY TUNER VIDEO MUTE VARIABLE FEEDBACK SET GAIN Switch to select general gain of the preamp to personal preferences. Due to a lack of current standards of power amp and preamp sensitivity this feature provides a simple method to scale the overall gain of the system or allow one to reduce the power amp gain to reduce noise. -
Page 7: Rear Panel
REAR PANEL C D E F G H I J K FUSE HOLDER Replace with 1A SLO-BLO fuse only. IEC MAINS SOCKET Standard IEC mains socket (120/240 VAC as indicated) OUTPUT (XLR) Left (upper) and Right (lower) output XLR's. BALANCED OUTPUT (RCA) Separate output to the Left and Right XLR outputs. -
Page 8: Operational Notes
OPERATIONAL NOTES SWITCHING ON The power switch is located on the right hand corner of the front panel. Flip the switch up to turn on the preamplifier and down to turn off the preamplifier. RUNNING It is not recommended that you leave your preamplifier permanently switched on. This only wastes electricity and tube life. -
Page 9: Specifications
SPECIFICATIONS Vacuum Tubes: 2 x 5751, 2 x 6414 (Mil Spec) Approved substitutions for 5751 12AX7A( or 6072 with less gain) Approved substitutions for 6414 12BH7 ( or 12AT7 in a pinch) Lamp type 1/4" X 1 1/4", 12 volt, .15 amp BAL ccw BAL cw Gain... -
Page 10: Warranty
If you believe this to be a new unit then please contact the factory with the details of purchase. This warranty is provided by the dealer where the unit was purchased, and by Manley Laboratories, Inc. Under the terms of the warranty defective parts will be repaired or replaced without charge, excepting the cost of tubes. -
Page 11: Warranty Registration
Registration entitles you to product support, full warranty benefits, and notice of product enhancements and upgrades. You MUST complete and return the following to validate your warranty and registration. Thank you again for choosing Manley Laboratories. MODEL PURIST PREAMP SERIAL No.__________________...
Need help?
Do you have a question about the Purist and is the answer not in the manual?
Questions and answers