Troubleshooting; Guarantee Conditions - Zibro Clima D10 Operating Manual

H
TROUBLE SHOOTING
If the dehumidifier is used according to this manual, you should enjoy trouble free
use. In cases of difficulty please check the following points before contacting your
Zibro Clima reseller.
Symptom
The
dehumidifier
does not start
Water is leaking
outside the
water
container.
Reduced water
extraction.
Not collecting
water.
The
dehumidifier
produces a
strange noise.
The units fan
doesn't seem to
be revolving.
I

GUARANTEE CONDITIONS

The dehumidifier is supplied with a 24-month guarantee, commencing on the
date of purchase. All material and manufacturing defects will be repaired or
replaced free of charge within this period. The following rules apply:
4
40
Check
Is the POWER light on?
Is the WATER FULL light
on?
Is HUMIDISTAT set to a high
relative humidity?
Has the unit been running in
cold temperatures under 4°C?
Has the water container been
removed for emptying straight
after the unit was running?
Is HUMIDISTAT set to a high
relative humidity?
Is the air already relatively dry?
Is the unit running in a cold
room? Generally the colder the
air, the less moisture will be
removed.
Is the WATER FULL light
on?
Is HUMIDISTAT set to a high
relative humidity?
Check whether the unit is placed
on a level surface.
Is the filter blocked up?
Solution
Make sure the unit is plugged
into a live mains socket. Check
the fuse in the plug and if
necessary replace with another
fuse.
Make sure the water container is
empty and fitted properly in
position
Select a lower humidity setting
or continuous running mode.
Only run the unit in a heated
space above 4°C.
Wait a few minutes to allow
condensation within the unit to
flow into the container after
switching off the unit and
before removing the container.
Select a lower humidity setting
or continuous running mode.
Select a lower humidity setting
or continuous running mode.
Extraction is reduced when the
humidity level is lower.
Ensure that the unit is operating
in a heated space above 4°C.
Make sure the water container is
empty and fitted properly in
position.
Select a lower humidity setting
or continuous running mode.
The unit should be placed on a
level surface.
Check the filter.