Emptying The Water Container - Zibro Clima D10 Operating Manual

ON
0 MAX
fig. 1
-
0
MAX
fig. 2
OFF
0 MAX
fig. 3
fig. 4
A
fig. 5
fig. 6
B
fig. 7
4
38
D
CONTROLS
0 MAX
1 To set the humidity controller
continuous working (see fig. 1).
2 The intensity of the humidity extraction is increased clockwise (see fig. 2).
To turn off the unit, turn the switch to position '0' (see fig. 3).
3
This dehumidifier features a twin speed fan. In normal conditions, set the
4
speed to . For quieter operation, set the speed to
IMPORTANT
Remember not to use this dehumidifier in temperatures below 4°C.
E

EMPTYING THE WATER CONTAINER

When the water container is full the indicator light
the unit will automatically shut off. Wait a few minutes to allow the water to
finish draining into the water container.
To remove the water container, disconnect from the mains, pull out and lift the
water container by the handle and carry it away for emptying. Gently replace the
container and close the lower front panel. When the tank is properly inserted,
both the hole and the float mechanism in the container will be located directly
beneath the drainage spout and the indicator light
F
CONTINUOUS DRAINAGE OPERATION
It may be more convenient to set up the dehumidifier for continuous drainage
with the following procedure:
Remove the water cap from the rear cabinet. Connect a water tube of
1
diameter 6 mm over the drainage spout (see fig. 5 and 6).
2 Pull out the water tank, put the water cap of the rear cabinet on the drain
hole B found in the compartment (see fig. 7).
Speed switch
Humidity controller
Power indicator
Water full indicator
to the required humidity level or 'MAX' for
(see fig. 4).
( ) will illuminate and
( ) will go out.