Goodmans GPS165MP3R Instruction Manual page 7

TYPES OF CASSETTE
Use only good quality cassettes (IEC TYPE 1) for making recordings. May be used to replay other types of cassette
but is unable to make proper recording on these more specialized tapes.
The use of C120 cassettes is NOT recommended in this machine.
PROTECTING RECORDING
Normally, anything recorded on the tape is automatically erased when new recording is made. It is possible to
protect your recording from accidental erasure by removing the tabs found on the rear of the cassette.
When the cassette is held with the recorded side upper-most and exposed tape facing the front, the protective
tab will be found on the left rear of the cassette.
All pre-recorded cassette are protected in this way to prevent accidental erasure of the commercial recording.
"Protected" cassette will prevent the record button from being operated. If at any time you attempt to record
and find that this button will not depress, never force the mechanism or it may be damaged. Check that a cassette
has been loaded and that tab has not been removed. Recording on a cassette from which the tabs have been
removed can be done by covering the tab openings with a piece of adhesive tape.
CARE OF CASSETTE MECHANISM
Use a cassette cleaning tape to clean the tape heads and mechanism. These are available from most high street
audio specialist.
USING THE CD/MP3
Discs for Playback
This system can playback all digital audio CD/MP3/WMA discs, finalized digital audio CD-Recordable (CD-R) discs
and finalized digital audio CD-Rewritable (CD-RW) discs.
LOADING A DISC
1. Set the FUNCTION switch to CD/MP3 position.
2. Open the CD door. " OP " will be shown on the display.
3. Place an audio CD/MP3 into the tray with the label side facing up.
4. Close the CD door. The total number of tracks and the disc type will appear on the display after several
seconds.
5. To remove the CD, press CD DOOR OPEN/CLOSE to open CD compartment lid, grasp the CD by its edges,
and carefully take it out.
Note:
To ensure good system performance; wait until the disc tray completely reads the disc before proceeding.
If no disc is loaded into the compartment, or the disc is placed upside down, the display will show "
Playing A Disc
1. Press the PLAY/PAUSE button to start playback, the playback starts from track 1, "
display. Adjust the volume by the VOLUME knob.
2. To interrupt playback, press the PLAY/PAUSE button, "
3. To resume playback, press the PLAY/PAUSE button again.
4. To stop playback, press the STOP button, the total number of tracks appears on the display.
Selecting A Different Track During Play
1. Press CD SKIP/SEARCH FORWARD/BACKWARD button continuously until the desired track number
appears in the display.
2. Playback starts from the desired track. (Press CD PLAY/PAUSE button to start playback in stop mode).
Starting Again With the Track That Is Currently Playing
1. Press CD SKIP/SEARCH BACKWARD button once.
2. The playback will start again from the beginning of the track.
" and the track number will flash on the display.
6
".
" will appear on the