Allied Telesis AT-8016F/MT Installation Manual page 64

Installation
Perform the following procedure to install the power supply in a
standard 19-inch rack. If you are not installing the power supply in a rack,
start with Step 7.
1. Place the unit upside down on a level, secure surface.
2. Using a flat-head screwdriver, remove the snap-on plastic feet from
the bottom of the power supply, as shown in Figure 30.
Figure 30 Removing the Feet
3. Turn the power supply over.
4. Attach a rackmounting bracket to one side of the power supply using
four of the screws that came with the power supply. See Figure 31.
Figure 31 Attaching Rackmounting Brackets
5. Install the second rackmounting bracket on the other side of the
power supply using the four remaining screws.
64