Xantech BDX TT Installation Instructions

INSTALLATION INSTRUCTIONS
BDX TT
Stereo Bluetooth Receiver
DESCRIPTION
The BDX TT is a Bluetooth receiver that allows a wireless connection to a Bluetooth
enabled device (mobile phone, PC, notebook, etc.), to allow the audio signal to be
played back wirelessly through speakers via an audio amplifier.
FEATURES AND SPECIFICATIONS
•
3-LED indicator to show modes of operation
•
Can be permanently operated with AC power OR Built-in rechargeable battery
for portable operation (approx. 10 hours Standby or 2 hours continuous music
playback)
•
Unique 3-digit alpha-numeric ID for identifying each individual receiver when
multiple units are used in one house.
•
1 - Stereo 3.5mm mini-plug-to-dual-RCA cable included (Length – 3.5ft / 1m)
•
1 - Stereo 3.5mm mini-plug-to-mini-plug cable included (Length – 3.5ft / 1m)
•
Frequency Response: 20 to 20 kHz (+/- 3dB)
•
Reception Range: up to 80 feet depending on housing structure and
environmental conditions.
•
Power Supply – INPUT: 100-240VAC 50/60Hz, 300mA - OUTPUT: 5VDC, 200mA
•
Worldwide power support with regional AC plugs for US, China, Japan, Europe,
UK, Australia, and New Zealand
•
Main unit dimensions – 3.5"(89mm) W x 1.25"(32mm) H x 3.25"(83mm) D
•
For indoor use only. Keep away from extreme temperatures, humidity, and
moisture.
First Use
Plug the included power adapter/recharger into an AC outlet and connect it to the "In
DC 5V" jack on the back of BDX TT (as shown in Fig. 1). The unit is ready for pairing
once power is applied (see next page). If there is a need to use the unit as a portable
Bluetooth receiver, its built-in battery will need to be fully charged. The first charge can
take up to 4 hours. Subsequent recharging may take less than 3 hours.
The middle LED Figure 1
(between the On/Off
buttons) will light
green to indicate that
the battery is
LEFT CHNL
charging. When it is
(TIP)
fully charged, the
RIGHT CHNL
green LED will turn
(RING)
off to indicate a full
GND/SHIELD
charge. (See Figure 2
(SLEEVE)
and Table 1 for
details)
To
Amplifier or
AV Receiver
REAR PANEL
Stereo
mini-plug-
Power
to-
Supply plug
dual RCA
cable
OR
To 120 VAC
Stereo mini-plug- (Unswitched)
to- mini-plug cable
1